Autotour

[Trausti Hraunfjord]

Autotour

[terrycm]

http://www.vimeo.com/12021990

password: ffcmembers

[ramirox3]

Many Thanks Terry
I ve been trying several times, but I have some questions.
The second part, move2 moves in the opposite direction that i state. I can fix it changing the code.
How do I get automatic movement in each pano of the tour, i´ve been trying but The tour returns to the first pano.
Thanks again
Ramiro

[terrycm]

If it moves in the opposite direction this is most likely due to the fact that your movement is to far away from your destination point. In other words the program will always find the shortest rout to your destination. To fix this you will need to create multiple move functions in ffc each moving you a little closer to your destination. Try that and let me know how it turns out.

[ramirox3]

Thanks Terry
Already understand about of movement.
[b]

How do I get automatic movement in each pano of the tour, I´ve been trying but The tour returns to the first pano

[/b ]???

on the other hand: How i do get tooltips over points not to be misaligned in mapper
Thanks again

[terrycm]

Could you post a screen shot of your problem so I can see?

[ramirox3]

printscreen.jpg (761.18 KiB) Viewed 2499 times

Thanks for your invaluable help

[terrycm]

WOW that is strange! This is a problem for Trausti to solve. Sorry about that.

[Trausti Hraunfjord]

That's ... well, what to say... the positive part of it is that the tooltip and the map are present in the same monitor....

... but only just.

Can you provide me with the .ffc file for the programmer to check what the heck is going on there?

Trausti

[ramirox3]

Hi Trausti Im sending .Fcc
Thanks in advance

[Trausti Hraunfjord]

The dimensions of the map are ... shall we say... BIG.

2131x2250 pixels to be exact.

The mapper will not be kind to a resized map... one of the issues that will be taken care of when it is rewritten.

So for the best results, try to resize the map image before including it in the tour. That should give you correct positions of the tooltips.

[kbellis]

Terry et als, I'm unsure how much has changed between when the video was made using FFC v2.086 and the current FFC (v2.0693) ... so I'm equally unsure about the various on-screen differences I observed as I studied this video.

I began with a blank slate whereas the video launches into a developed project with many defined hotspots already in the lower drawer (or whatever it is properly called), one of them (dinfoscreen) highlighted and in Box (state?, mode?, depth?). While Terry ever so briefly drags his mouse toward the highlighted tab (dinfoscreen), it's unclear to me what significance - if any - there is in this highlighted hotspot.

So my first question and just to make sure that I'm not assuming too much, are the documented steps without any consideration to whether or not a single hotspot exists?